This is a fantastic way to make a CO2/Nitrogen gas board so you can control, monitor and display the different pressures to a multi-keg draft system.

These regulator gas boards are the ideal way to mount your mini inline regulators to your wall so you can supply gas to various kegs at different pressures. The mounting holes for the wall mounting are pre-drilled, as are the holes for the regulators, which makes installation very easy.

Dimensions : 260mm x 420mm

This is the Gas Board Only.
To make up the gas board, we recommend purchasing these parts separately:

6 x Inline Regulators
11 x Rigid 8mm Joiners
5 x duotight 8mm Tee Pieces
1 x duotight 8mm Elbow

You will also need some small screws to mount the inline regulators - 6g-8g, 12-15mm will do the trick.

NOTE: This can also be used to wall mount your blowtie fittings.  So if you wanted to use the gas board to show residual pressure inside a fermenter, you can remove one of the inline regulators and replace it with one of these Blowtie Spunding Valves